robedj
04-20-2005, 05:27 AM
I have a CARK-91 that I have used my 6310i in for years with no probs. I have just upgraded to a 6320 and wondered if I could mod the cradle to accept a cable from the 6320.
If so, what cable do I require. I have the pinouts for the two phones shown below. What does MBUS and FBUS pins do? Do I really need to care about them if all I require is the audio out of the phone?
Any advice would be well received.
6310i Pin 1 is to the left of the round power connector then read from left to right.
pin 6 - MBUS
pin 7 - Rx
pin 8 - Tx
pin 9 - GND
6320 Pin 1 is to the right of the round power connector the first in the bank of pins
pin 1 - Charge
pin 2 - Charge GND
pin 3 - ACI
pin 4 - Vout
pin 5 - USB Vbus
pin 6 - FBUS_Rx / USB D+
pin 7 - FBUS_Tx / USB D-
pin 8 - Data GND
If so, what cable do I require. I have the pinouts for the two phones shown below. What does MBUS and FBUS pins do? Do I really need to care about them if all I require is the audio out of the phone?
Any advice would be well received.
6310i Pin 1 is to the left of the round power connector then read from left to right.
pin 6 - MBUS
pin 7 - Rx
pin 8 - Tx
pin 9 - GND
6320 Pin 1 is to the right of the round power connector the first in the bank of pins
pin 1 - Charge
pin 2 - Charge GND
pin 3 - ACI
pin 4 - Vout
pin 5 - USB Vbus
pin 6 - FBUS_Rx / USB D+
pin 7 - FBUS_Tx / USB D-
pin 8 - Data GND